Supermicro SSE-X24S - Configuring Startup Configuration File Name

Supermicro L2/L3 Switches Configuration Guide
79
The example below shows the commands used to write an existing switch configuration to a file.
SMIS# write flash:r1sw1.conf
Building configuration, Please wait. May take a few minutes ...
[OK]
SMIS# writetftp://192.168.1.100/r1sw1.conf
Building configuration, Please wait. May take a few minutes ...
[OK]
SMIS# show stored-config r1sw1.conf
vlan 1
ports gi 0/1-48 untagged
ports ex 0/1-4 untagged
exit
snmp view restricted 1 excluded nonvolatile
set ip igmp enable
set ip pim enable
ip pim component 1
exit
1.9.3 Configuring Startup Configuration File Name
Supermicro switches provide an option to select a file stored in flash memory as the startup
configuration file that gets loaded when the switch is powered ON or restarted.
Follow the steps below to configure the Startup configuration.
Step Command Description
Step 1
configure te
rminal
Enters the configuration mode
.
Step 2
set startup
-
config<
filename
>
Configure
s the
s
tartup
config
uration
file
name.
filename – name of the configuration
file.
Step 3
end
Exits the configuration mode.
Step 4
show startup
-
config
Displays the configured startup
configuration file contents.
The example below shows the commands used to configure the switch startup configuration.
SMIS# configure terminal