Supermicro SSE-X24S - Copy Startup Configuration; Copy File

Supermicro L2/L3 Switches Configuration Guide
80
SMIS(config)# set startup-config config2.conf
SMIS(config)# end
SMIS# show startup-config
vlan 1
ports gi 0/1-48 untagged
ports ex 0/1-4 untagged
exit
snmp view restricted 1 excluded nonvolatile
set ip igmp enable
set ip pim enable
ip pim component 1
exit
1.9.4 Copy Startup Configuration
Supermicro switches can copy a switch’s startup configuration to a file in flash or to a remote location.
Follow the steps below to copy the startup configuration to a file in remote location or to flash.
Step Command Description
Step 1
copy startup
-
config
{flash:
filename
| tftp://ip
-
address/filename| usb:filename }
Copy from
the
startup
config
uration
to
a file in remote location or flash or the
external USB memory.
filename – name of the configuration
file.
The example below shows the commands used to copy from the startup configuration to a file in flash.
SMIS# copy startup-config flash:config5.txt
Copied startup-config => flash:/mnt/config5.txt
SMIS#
1.9.5 Copy File
The copy command helps copying the configuration files from flash memory to remote TFTP server and
vice versa. This command can be used to copy files in the local flash memory also.
Follow the steps below to Copy a file to another file in remote site/flash.
Step Command Description
Step 1
copy flash:
filename
tftp://ipaddress/
filename
Copies a local flash file to
a
remote
TFTP server.