Supermicro SSE-X24S - Firmware Failure Recovery Steps

Supermicro L2/L3 Switches Configuration Guide
42
Time zone offset not set
1.6.3 System Location
Supermicro switches provide an option to configure the switch location details.
Follow the steps below to configure system location.
Step Command Description
Step 1
configure terminal
Enters the configuration mode
.
Step 2
system location <location name>
Configure
s the
s
ystem
l
ocation.
location name – Location of the switch
specified as a string with a maximum
size of 256.
Step 3
end
Exits the configuration mode.
Step 4
show system information
Displays the
s
ystem
l
ocation
configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
T
he
System Location
configuration is automatically stored as part of
the
startup
-
configuration file.
The example below shows the commands used to configure system location.
SMIS# configure terminal
SMIS(config)# system location "Santa Clara"
SMIS(config)# end
SMIS# show system information
Switch Name: SMIS
Switch Base MAC Address: 00:30:48:e3:70:bc
SNMP EngineID: 80.00.08.1c.04.46.53
System Contact: http://www.supermicro.com
System Location: Santa Clara
Logging Option: Console Logging
Login Authentication Mode: Local
Snoop Forward Mode: MAC based
Config Restore Status: Not Initiated
Config Restore Option: No restore
Config Restore Filename: iss.conf
Config Save IP Address: 0.0.0.0