Supermicro SSE-X24S - 1-6 Contacting Supermicro

Supermicro L2/L3 Switches Configuration Guide
18
1.4.1 Description
Supermicro switches allow users to configure a description string for the interfaces. This descriptive
string will be useful to easily identify the interfaces.
Follow the steps below to configure the interface description string.
Step Command Description
Step 1
configure terminal
Enters the configuration mode
.
Step 2
interface
<
interface
-
type
><
interface
-
id
>
or
interface range <interface-type><interface-id> ….
Enters the interface configuration
mode.
interface-type – may be any of the
following:
gigabitethernet – gi
extreme-ethernet – ex
qx-ethernet – qx
vlan
interface-id is in slot/port format for all
physical interfaces. It may be the VLAN
identifier for VLAN interfaces.
To configure multiple interfaces, use
the “interface range …” command. To
provide a range, use a hyphen (-)
between the start and end interface
numbers. E.g.: int range gi 0/1-10
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g.: int range gi 0/1-10, gi 0/20
If multiple interfaces are provided, the
next step will perform the particular
configuration on all these interfaces.
Step 3
description
<
string
>
Configure
s
the interface description
.