Supermicro SSE-X24S - Management Access

Supermicro L2/L3 Switches Configuration Guide
9
The
IP Gateway
configuration is saved automatically as part of
the
start
-
up
config
uration
.
The “no ip gateway” command resets the switch IP gateway address to its default value of
0.0.0.0.
The example below shows the commands used to configure the gateway IP address.
SMIS# configure terminal
SMIS(config)# ip gateway 10.1.1.1
SMIS(config)# end
In TOR switches, the above “ip gateway” command is not supported. To configure the gateway IP
address use the “ip route” command.
To configure default gateway address in TOR switches, follow the steps below.
Step Command Description
Step 1
configure terminal
Enters the configuration mode
.
Step 2
ip route 0.0.0.0 0.0.0.0 <ip
-
address>
Configure
the
IP gateway
address
.
ip-address – IP address of a directly
connected gateway.
Step 3
end
Exits the configuration mode.
Step
4
show ip
route
Displays the IP route configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The
“no iproute 0.0.0.0 0.0.0.0 <ip
-
address>”
command
removes the gateway
configuration.
The example below shows the commands used to configure IP gateway in TOR switches.
SMIS# configure terminal
SMIS(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1
SMIS(config)# end
1.2 Management Access
Supermicro switches can enable access control of the switch by various mechanisms: