Supermicro SSE-X24S - Installation Instructions

Supermicro L2/L3 Switches Configuration Guide
21
If multiple interfaces are pr
ovided, the
next step will perform the particular
configuration on all these interfaces.
Step3
negotiation
Enable
s
Interface Negotiation
.
Step 4
end
Exits the configuration mode.
Step 5
show interface status
Displays the interface configuration.
Step 6
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The
“no negotiation”
command
disables interface negotiation.
The example below shows the commands used to configure Interface Negotiation.
SMIS# configure terminal
SMIS(config)# interface Gi 0/22
SMIS(config-if)# no negotiation
SMIS(config-if)# end
SMIS# show interface status
Port Status Duplex Speed Negotiation
---- ------ ------ ----- -----------
Gi0/1 not connected Full 1 Gbps Auto
Gi0/2 not connected Full 1 Gbps Auto
Gi0/3 not connected Full 1 Gbps Auto
Gi0/4 not connected Full 1 Gbps Auto
Gi0/5 not connected Full 1 Gbps Auto
Gi0/6 not connected Full 1 Gbps Auto
Gi0/7 not connected Full 1 Gbps Auto
Gi0/8 not connected Full 1 Gbps Auto
Gi0/9 not connected Full 1 Gbps Auto
Gi0/10 not connected Full 1 Gbps Auto
Gi0/11 not connected Full 1 Gbps Auto
Gi0/12 not connected Full 1 Gbps Auto
Gi0/13 not connected Full 1 Gbps Auto
Gi0/14 not connected Full 1 Gbps Auto
Gi0/15 not connected Full 1 Gbps Auto
Gi0/16 not connected Full 1 Gbps Auto
Gi0/17 not connected Full 1 Gbps Auto
Gi0/18 not connected Full 1 Gbps Auto