Supermicro SSE-X24S - Battery Handling

Supermicro L2/L3 Switches Configuration Guide
27
vlan
port-channel
interface-id is in slot/port format for all
physical interfaces. It may be the VLAN
identifier for VLAN interfaces.
To configure multiple interfaces, use
the “interface range …” command. To
provide a range, use a hyphen (-)
between the start and end interface
numbers. E.g.: int range gi 0/1-10
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g.: int range gi 0/1-10, gi 0/20
If multiple interfaces are provided, the
next step will perform the particular
configuration on all these interfaces.
Step 3
mtu<frame
-
si
ze(1500
-
9216)>
Configure interface MTU
to
a
range
of
1500-9216.
Step 4
end
Exits the c
onfiguration mode.
Step 5
show interface status
Displays the interface configuration.
Step 6
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The
“no mtu”
command
restores the
i
nterface MTU to its default of 1500 bytes.
To change the MTU for all the interfaces, the “system mtu” command can be used.
The example below shows the commands used to configure the interface MTU.
SMIS# configure terminal
SMIS(config)# interface Gi 0/22
SMIS(config-if)# mtu 9000
SMIS(config-if)# end