Supermicro SSE-X3348S - Statistics Refresh Timer; Interface Properties

Supermicro L2/L3 Switches Configuration Guide
17
SMIS(config)# web session-timeout 500
SMIS(config)# end
1.3.4 Statistics Refresh Timer
The statistics pages can be configured to automatically refresh periodically. The web statistics refresh
timer is configurable through a CLI command.
Follow the steps below to configure the Statistics Refresh Timer.
Step Command Description
Step 1
configure terminal
Enters the configuration mode
.
Step 2
statistics refresh
-
timer <integer(0
-
9999)>
Configure
s the
Statistics Refresh Timer
to between 1-9999 seconds.
Step 3
end
Exits the configuration mode.
Step 4
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The example below shows the commands used to configure the Statistics Refresh Timer.
SMIS# configure terminal
SMIS(config)# statistics refresh-timer 5000
SMIS(config)# end
1.4 Interface Properties
Supermicro switches support various types of interfaces: physical interfaces, port channel interfaces and
VLAN interfaces. Each interface has different characteristics, some of which are configurable.
Defaults – Interface Properties
Parameter Default Value
MTU
1500 bytes
Speed
For 1
–
1Gbps
For 10 – 10Gbps
For 40 – 40Gbps
Negotiation
For 1G interfaces
–
Auto
For 10GBaseT interfaces – Auto
For all other types of 10G interfaces – No negotiation
For 40G interfaces - No negotiation
Storm
-
control
Disabled
Description
None
Duplex Operation
Full
Flow Control
Off