Supermicro SSE-X3348S - Reset to Factory Defaults

Supermicro L2/L3 Switches Configuration Guide
84
SMIS# configure terminal
SMIS(config)# set boot-up fallback
SMIS(config)# end
SMIS# show system information
Switch Name: SMIS
Switch Base MAC Address: 00:30:48:e3:70:bc
SNMP EngineID: 80.00.08.1c.04.46.53
System Contact: http://www.supermicro.com/support
System Location: Supermicro
Logging Option: Console Logging
Login Authentication Mode: Local
Snoop Forward Mode: MAC based
Config Restore Status: Not Initiated
Config Restore Option: No restore
Config Restore Filename: iss.conf
ConfigSave IP Address : 0.0.0.0
Device Up Time: 0 days 0 hrs 0 mins 53 secs
Boot-up Flash Area: Fallback
NTP Broadcast Mode: No
[NTP] ntp is disabled
Server Key Prefer
=============== ===== ======
Key # Key
======= ====================================
Time zone offset not set
1.9.9 Reset to Factory Defaults
Supermicro switches can be reset to factory defaults using a CLI command.
Follow the steps below to reset a switch to its factory defaults.
Step Command Description
Step 1
configure terminal
Enters the configuration mode
.
Step 2
reset
-
to
-
factory
-
defaults
Configure
s the f
actory
d
efaults.