Supermicro SSE-X3348S - Save Running Configuration to File

Supermicro L2/L3 Switches Configuration Guide
78
Step Command Description
Step 1
write
startup
-
confi
g
Configure
w
riting of
s
witch
c
onfiguration to
a file or startup-configuration.
Step 2
show startup
-
config
Displays the startup configuration.
The example below shows the command used to write existing switch configuration as startup-config.
SMIS# write startup-config
Building configuration, Please wait. May take a few minutes ...
[OK]
To change the default startup config file name, use the “set startup
-
config” command.
1.9.2 Save Running Configuration To File
Switch configurations can be saved to a file either in local flash memory or to a remote TFTP server.
Follow the steps below to write an existing switch configuration to a file.
Step Command Description
Step 1
write { flash:
filename
| tftp://ip
-
address/filename|usb:filename}
Configure
the w
riting of
the s
witch
configuration to a file in the local flash
memory, in a remote TFTP server or in
the external USB memory.
filename – name of the configuration
file.
Step 2
show stored
-
config<
filename
>
Displays the
stored configuration
file
from local flash memory.
filename – name of the configuration
file.
The
external USB memory is available only in SSE
-
X24S, SSE
-
X3348S and SSE
-
X3348T
switches.