Supermicro SSE-X3348S - NTP Authentication

Supermicro L2/L3 Switches Configuration Guide
35
=============== ===== ======
200.200.200.10 100 YES
100.100.100.1 500
Key # Key
======= ====================================
Time zone offset not set
1.5.3 NTP Authentication
Supermicro switches support NTP authentication by the NTP server. The authentication data is
encrypted by an MD5 algorithm. The NTP authentication key can be configured in the switch and this
must be matched with the NTP authentication key in the NTP server. The authentication key is an NTP
key number and text pair.
Step Command Description
Step 1
configure term
inal
Enters
the configuration mode
.
Step 2
ntp key <key_number (1- 65535)><key_text>
Configure
s
NTP authentication key.
Key-number –key number in the range
of 1-65535, used for MD5.
Key-text – NTP key text to be used
along with the key-number for MD5.
Step 3
end
Exits the configuration mode.
Step 4
show ntp
Displays the
NTP
configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The
“
no ntp key
”
command
deletes the NTP
authentication key
.
The example below shows the commands used to configure the NTP.
SMIS(config)# ntp key 200 For-server1
SMIS(config)# show ntp
[NTP] ntp is enabled