Supermicro SSE-X3348S - Configuration Management; Save Startup Configuration

Supermicro L2/L3 Switches Configuration Guide
77
implementation
,
refer
to
the openssl
documentation to find the equivalent
steps.
Execute the commands below in the
Linux shell.
1. openssl req -x509 -newkey
rsa:1024 -keyout cakey.pem -
out cacert.pem
2. openssl x509 -req -in a.csr -out
cert.pem -CA cacert.pem -
CAkey cakey.pem –
Cacreateserial
This would generate the certificate file
cert.pem.
Step 5
ssl
server
-
cert
Open the generate certificate file
cert.pem. Delete the first line (---BEGIN
CERTIFICATE ---) and last line (----END
CERTIFICATE--). Join all the remaining
lines together as a single line to avoid
line breaks from being processed.
Copy & paste these joined texts at the
“Enter Certificate” prompt. This
prompt appears after entering the “ssl
serv-cert” command in CLI.
This step would configure the
certificate and save it to flash.
Step 6
show ssl server
-
cert
Displays the SSL configuration.
1.9 Configuration Management
This section describes the steps to save and manage the configuration files on the switch. It also
describes the firmware upgrade and the “restore to factory defaults” functions.
1.9.1 Save Startup Configuration
Switch configurations can be saved using the command write startup-config. A configuration saved as a
startup configuration will be loaded automatically when a switch reboots. The default startup
configuration file name is iss.conf. This startup configuration file is stored in the flash memory.
Follow the steps below to write an existing switch configuration as the startup configuration.