Supermicro SSE-X3348S - Page 38

Supermicro L2/L3 Switches Configuration Guide
38
Step 1
configure terminal
Enters the configuration mode
.
Step 2
tz offset HH<
-
12 to 13>:MM<0, 30 or 45>
Configure the timezone.
HH – Hour in range -12 to 13.
MM – Minutes specified as 0, 30 or 45.
Step 3
end
Exits the
configuration mode.
Step 4
show system information
Displays the timezone configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The example below shows the commands used to configure the timezone offset.
SMIS# configure terminal
SMIS(config)# tz offset 12:30
SMIS(config)# end
SMIS# show system information
Switch Name: SMIS
Switch Base MAC Address: 00:30:48:e3:70:bc
SNMP EngineID: 80.00.08.1c.04.46.53
System Contact: http://www.supermicro.com/support
System Location: Supermicro
Logging Option: Console Logging
Login Authentication Mode: Local
Snoop Forward Mode: MAC based
Config Restore Status: Not Initiated
Config Restore Option: No restore
Config Restore Filename: iss.conf
Config Save IP Address: 0.0.0.0
Device Up Time: 0 days 0 hrs 48 mins 5 secs
Boot-up Flash Area: Normal
NTP Broadcast Mode: No
[NTP] ntp is disabled
Server Key Prefer
=============== ===== ======
Key # Key
======= ====================================
Time zone offset value: 12:30