Supermicro SSE-X3348S - Page 72

Supermicro L2/L3 Switches Configuration Guide
72
Parameter Default Value
SSH
status
Enabled
SSH version compa
ti
bility
Off
SSH port
22
SSH Key
RSA
Cipher
a
lgorithm
3DES
-
CBC
SSH
v
ersion
2
Authentication
HMAC
-
SHA1
Follow the steps below to configure SSH.
Step Command Description
Step 1
configure terminal
Enters the configuration mode
.
Step 2
ip ssh {version compatibility | cipher ([des
-
cbc]
[3des-cbc]) | auth ([hmac-md5] [hmac-sha1]) |
port <(1024-65535)>}
version
compa
ti
bility
-
Specif
ies
whether
switch should process both version 1
and version 2 SSL messages.
cipher – Specifies the encryption
algorithm.
auth –Specifies the authentication
algorithm.
port - Specifies the SSH port, from
1024-65535
Step 3
end
Exits the
configuration mode.
Step 4
show ip ssh
Displays the
SSH
configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The
“
no ip ssh {version compatibility | cipher ([des
-
cbc] [3des
-
cbc])
| auth ([hmac
-
md5]
[hmac-sha1]) | port <(1024-65535)>}” command disables SSH.
The example below shows the commands used to configure the SSH.
SMIS# configure terminal
SMIS(config)# ip ssh version compatibility
SMIS(config)# end
SMIS# show ip ssh
Version: Both
Cipher Algorithm: 3DES-CBC
Authentication: HMAC-SHA1