Supermicro SUPERSERVER 1028R-TDW - Circuit Overloading; Reliable Ground; Installing the System into a Rack; Identifying the Sections of the Rack Rails

WIT.RU
WIT Company – поставка серверов, СХД,
сетевого оборудования, лицензионного ПО
Chapter 2: Server Installation
2-52-4
SUPERSERVER 1028R-TDW USER'S MANUAL
Circuit Overloading
Consideration should be given to the connection of the equipment to the power
supply circuitry and the effect that any possible overloading of circuits might have
on overcurrent protection and power supply wiring. Appropriate consideration of
equipment nameplate ratings should be used when addressing this concern.
Reliable Ground
A reliable ground must be maintained at all times. To ensure this, the rack
itself should be grounded. Particular attention should be given to power supply
connections other than the direct connections to the branch circuit (i.e. the use of
power strips, etc.).
2-5 Installing the System into a Rack
This section provides information on installing the SuperServer 1028R-TDW into a
rack. If the SuperServer 1028R-TDW has already been mounted into a rack, you
can skip ahead to Sections 2-5 and 2-6.
Note: This rail will t a rack between 26" and 33.5" deep.
There are a variety of rack units on the market, which may mean the assembly
procedure will differ slightly. The following is a guideline for installing the SuperServer
1028R-TDW into a rack with the rack rails provided. You should also refer to the
installation instructions that came with the rack unit you are using.
Identifying the Sections of the Rack Rails
Each assembly consists of two sections: an inner xed chassis rail that secures
directly to the server chassis and an outer xed rack rail that secures directly to
the rack itself.
Figure 2-1. Identifying the Sections of the Rack Rails
Inner Rails
Inner Rail
Extensions
Note: system pictured above includes an optional DVD drive.