Supermicro SUPERSERVER 1028R-TDW - Security Settings

WIT.RU
WIT Company – поставка серверов, СХД,
сетевого оборудования, лицензионного ПО
Chapter 7: BIOS
7-357-34
SUPERSERVER 1028R-TDW User's Manual
When SEL is Full
This feature allows the user to determine what the AMI BIOS should do when the
system event log is full. Select Erase Immediately to erase all events in the log when
the system event log is full. The options are Do Nothing and Erase Immediately.
Note: After making changes on a setting, be sure to reboot the system for
the changes to take effect.
BMC Network Conguration
The following items will be displayed:
Update IPMI LAN Conguration
Select Yes for the system BIOS to automatically reset the following IPMI settings
at next system boot. The options are Yes and No.
Conguration Address Source (Available when the item above - Update
IPMI LAN Conguration is set to Yes)
Use this item to select the IP address source for this computer. If Static is selected,
you will need to know the IP address of this computer and enter it to the system
manually in the eld. If DHCP is selected, AMI BIOS will search for a DHCP (Dy-
namic Host Conguration Protocol) server attached to the network and request the
next available IP address for this computer. The options are DHCP, and Static.
Station IP Address
This item displays the Station IP address for this computer. This should be in decimal
and in dotted quad form (i.e., 192.168.10.253).
Subnet Mask
This item displays the sub-network that this computer belongs to. The value of each
three-digit number is separated by dots and it should not exceed 255.
Station MAC Address
This item displays the Station MAC address for this computer. Mac addresses are
6 two-digit hexadecimal numbers.
Gateway IP Address
This item displays the Gateway IP address for this computer. This should be in
decimal and in dotted quad form (i.e., 192.168.10.253).
7-6 Security Settings
This menu allows the user to congure the following security settings for the
system.
Administrator Password
Use this feature to set the administrator password which is required before the
user entering the BIOS setup utility. The length of the password should be from
3 characters to 20 characters long.
User Password
Use this feature to set the user password which is required to enter the BIOS
setup utility. The length of the password should be from 3 characters to 20 char-
acters long.