WIT.RU
WIT Company – поставка серверов, СХД,
сетевого оборудования, лицензионного ПО
1-2 1-3
Chapter 1: Introduction
SUPERSERVER 1028R-TDW User's Manual
1-2 Serverboard Features
At the heart of the SuperServer 1028R-TDW lies the X10DDW-i, a dual processor
serverboard based on the Intel® C612 chipset. Below are the main features of the
X10DDW-i. (See Figure 1-1 for a block diagram of the chipset).
Processors
The X10DDW-i supports two Intel® Xeon E5-2600 (v3/v4) series processors in an
R3-LGA2011 socket. Please refer to our website for a complete listing of supported
processors (www.supermicro.com).
Memory
The X10DDW-i has 16 DIMM sockets that can support up to 2 TB of DDR4-
2400/2133/1866/1600 LRDIMM (Load Reduced DIMMs), or 512 GB of RDIMM
(registered DIMMs) DDR4-2400/2133/1866/1600 memory. Please refer to Chapter
5 for installing memory.
SATA
A SATA controller is integrated into the chipset to provide a ten-port, SATA subsys-
tem, which is RAID 0, 1, and 10 supported. The SATA drives are hot-swappable
units. The serverboard also supports the use of a SATA DOM device.
Rear I/O Ports
The rear I/O ports include one VGA (monitor) port, two USB 2.0 ports, two USB 3.0
ports, two Gb LAN ports and a dedicated IPMI LAN port.
1-3 Server Chassis Features
The SC113TQ-600WB is Supermicro's third-generation 1U chassis and features
eight 2.5" hard drive bays and one high-efciency power supply. The following is a
general outline of the main features of the SC113TQ-600WB chassis.
System Power
When congured as a SuperServer 1028R-TDW, the SC113TQ-600WB chassis
includes a single 600 watt power supply.
Hard Drive Subsystem
The SC113TQ-600WB chassis was designed to support eight hot-swap SATA
hard drives.
PCI Expansion Slots
Two riser cards (RSC-R1UW-2E16-O-P and RSC-R1UW-E8R-O-P) on the left
side of the chassis can support two PCI-E x16 and one PCI-E x8 expansion cards,
respectively. See section 5-6 for further details.)
Front Control Panel
The SC113TQ-600WB control panel provides important system monitoring and
control information. LEDs indicate power on, network activity, hard disk drive activ-
ity and a UID (Universal Information) LED. Also present are a main power button,
a system reset button and a UID button.
Cooling System
The SuperServer 1028R-TDW has an innovative cooling design that features ve
sets of 4-cm counter-rotating fans located in the middle section of the chassis.
There is a "Fan Speed Control Mode" setting in IPMI that allows chassis fan speed
to be determined by system temperature. The power supply module also includes
a cooling fan.
To Next Page
Loading...
