1-2
SUPERSERVER 1028TR-T/TF User's Manual
1-2 Serverboard Features
At the heart of the SuperServer 1028TR-T/TF lies the
X10DRT-L/LIBF, a dual processor serverboard based on the Intel®
C612 chipset and designed to provide maximum performance. Two of these
serverboards can be mounted in the SC809TS-1K03BP chassis.
The sections below cover the main features of the X10DRT-L/LIBF serverboard
(see Figure 1-1 for a block diagram of the chipset).
Processors
The X10DRT-L/LIBF supports single or dual Intel® Xeon® E5-2600 v3 Series
processors (Socket R3-LGA 2011). Please refer to the serverboard description
pages on our web site for a complete listing of supported processors (www.
supermicro.com).
Memory
The X10DRT-L/LIBF has eight (8) DIMM slots supporting up to 256 GB of RDIMM
registered ECC or 512 GB of LRDIMM DDR4 (288-pin) ECC 2133/1866/1600 MHz
speed SDRAM in 512 MB, 1 GB, 2 GB, 4 GB, 8 GB, 16 GB, 32 GB or 64 GB sizes
at 1.2V voltages. See Chapter 5 for details.
Note: Check the Supermicro website (www.supermicro.com) for the latest memory
support information.
Serial ATA
A Serial ATA controller is integrated into the C612 to provide up to twelve SATA3
ports, (six SATA 3 (6 Gb/s) (I-SATA 0-5) and four S-SATA 3 (6 Gb/s) (S-SATA 0-3),
RAID 0, 1, 5 and 10 supported. The SATA drives are hot-swappable units.
Note: The operating system you use must have RAID support to enable the hot-
swap capability and RAID function of the SATA drives.
Note: S-SATA2/S-SATA3: can be used as Supermicro SuperDOM (Disk-on-Module)
with built-in power connectors.
PCI Expansion Slots
The SuperServer 1028TR-T/TF has for each node One (1) PCI-Express 3.0 x16 slot
available for use with a riser card.
To Next Page
Loading...
