Supermicro SUPERSERVER 1028TR-T - Connecting the Control Panel

Chapter 5: Advanced Motherboard Setup
5-3
Connecting the Control Panel
JF1 contains header pins for various front control panel connectors. See Figure 5-1
for the pin locations of the various front control panel buttons and LED indicators.
Even and odd numbered pins are on opposite sides of each header.
All JF1 wires have been bundled into single keyed ribbon cable to simplify their
connection. The red wire in the ribbon cable plugs into pin 1 of JF1. Connect the
other end of the cable to the Control Panel printed circuit board, located just behind
the system status LEDs in the chassis.
See the Connector Defi nitions section in this chapter for details and pin descriptions
of JF1.
Figure 5-2. Front Control Panel Header Pins (JF1)
1
2
Ground
19
20
X
X
FP PWRLED
3.3 V
HDD LED
UID Switch
NIC1 Link LED
NIC1 Activity LED
NIC2 Link LED
NIC2 Activity LED
UID LED
OH/Fan Fail/
PWR Fail LED)
Power Fail LED
3.3V
Reset Button
Power Button
Ground
Ground
X