5-14
SUPERSERVER 1028TR-T/TF User's Manual
Notes:
1. For the latest CPU/Memory updates, please refer to our website at http://
www.supermicro.com/products/motherboard/ for details.
2. Use only the correct type of onboard CMOS battery as specifi ed by the
manufacturer. Do not install the onboard battery upside down to avoid
possible explosion.
3. Jumpers not indicated are for test purposes only.
4. All graphics shown in this manual were based upon the latest PCB Revision
available at the time of publishing of the manual. The motherboard you've
received may or may not look exactly the same as the graphics shown in this
manual.
X10DRT-L/LIBF Quick Reference
Jumper Description Default Setting
JBT1 Reset BIOS Confi guration See Chapter 2
JIB1 Infi ni-Band (IB) Enable (For X10DRT-LIBQ/LIBF) Pins 1-2 (Enabled)
JI
2
C1/JI
2
C2 SMB to PCI-E Slots Pins 2-3 (Disabled)
JPB1 BMC Enable Pins 1-2 (Enabled)
JPG1 VGA Enable Pins 1-2 (Enabled)
JPL1 GLAN1/GLAN2 Enable Pins 1-2 (Enabled)
JPME2 Manufacture (ME) Mode Select Pins 1-2 (Normal)
JWD1 Watch Dog Timer Enable Pins 1-2 (Reset)
LED Description State Status
LE1 UID LED Blue: On Unit Identifi ed
LE8 HDD LED On HDD Active
LEDBMC BMC Heartbeat LED Green: Blinking BMC Normal
LEDPWR Standby Power LED On Power On
To Next Page
Loading...
