5-18
SUPERSERVER 1028TR-T/TF User's Manual
Video Connection
A Video (VGA) port is located next to COM1 on the I/O back panel. Refer to the
board layout below for its location.
Serial Ports
A COM port (COM1) is located on the I/O back panel to provide serial link
connections for the system. Refer to the table on the right for pin-out defi nitions.
HDD/UID LED
The HDD LED connection is located on
pins 13 and 14 of JF1. Attach a cable to
pin 14 to show the HDD activity status.
Attach a cable to pin 13 to use the UID
switch. See the table on the right for pin
defi nitions.
HDD LED
Pin Defi nitions
(JF1)
Pin# Defi nition
13 3.3V Standby
14 HD Active
Power On LED
The Power LED connection is located
on pins 15 and 16 of JF1. Refer to the
table on the right for pin defi nitions.
Power LED
Pin Defi nitions
(JF1)
Pin# Defi nition
15 3.3V
16 PWR LED
NIC1 LED
Pin Defi nitions (JF1)
Pin# Defi nition
9 NIC 2 Activity LED
10 NIC 2 Link LED
11 NIC 1 Activity LED
12 NIC 1 Link LED
NIC1/NIC2 LED Indicators
The NIC (Network Interface Controller)
LED connection for LAN port 1 is located
on pins 11 and 12 of JF1, and the LED
connection for LAN port 2 is on pins 9
and 10. Attach the NIC LED cables here
to display network activity. Refer to the
table on the right for pin defi nitions.
NMI Button
The non-maskable interrupt button
header is located on pins 19 and 20 of
JF1. Refer to the table on the right for
pin defi nitions.
NMI Button
Pin Defi nitions
(JF1)
Pin# Defi nition
19 Control
20 Ground
To Next Page
Loading...
