SuperServer 1029P-MT/MTR User's Manual
24
Chapter 3
Maintenance and Component Installation
This chapter provides instructions on installing and replacing main system components. To
numbers given.
system. Please follow the procedures given in each section.
3.1 Removing Power
Use the following procedure to ensure that power has been removed from the system. This
step is necessary when removing or installing non hot-swap components or when replacing
a non-redundant power supply.
1. Use the operating system to power down the system.
2. After the system has completely shut-down, disconnect the AC power cord(s) from the
power strip or outlet. (If your system has more than one power supply, remove the AC
power cords from all power supply modules)
3. Disconnect the power cord(s) from the power supply module(s).
3.2 Accessing the System
The SC113MFTS-605CBP/R608CBP features a removable top cover, which allows easy
access to the inside of the chassis.
Removing the Top Cover
1. Power down the system as described in Section 3.1.
2. Slide the cover toward the rear of the chassis.
3. Lift the cover from the chassis.
To Next Page
Loading...
