Supermicro SuperServer 1029P-MT - Control Panel

46
SuperServer 1029P-MT/MTR User's Manual
Control Panel


All JF1 wires have been bundled into a single cable to simplify this connection. Make sure
the red wire plugs into pin 1 as marked on the motherboard. The other end connects to the
control panel PCB board.
Figure 4-1. JF1: Control Panel Pins
Power Button
OH/Fan Fail LED
1
Reset Button
2
Power Fail
HDD LED
Power LED
Reset
PWR
UID LED
Ground
Ground
19 20
3.3V
X
Ground
NMI
X
NIC2 Activity LED3.3V Stby
3.3V Stby
3.3V Stby
NIC1 Activity LED
3.3V
Power Button
Pin Denitions (JF1)
Pins Denition
1 Signal
2 Ground
Power Button
The Power Button connection is located on pins 1 and 2 of JF1. Momentarily contacting both

button (with a setting in the BIOS - see Chapter 4). To turn off the power when the system
is in suspend mode, press the button for 4 seconds or longer. Refer to the table below for

RAID Key Header
A RAID Key header is located at JRK1 on the motherboard. The RAID key is used to support
CPU NVMe SSD.