Supermicro SuperServer 4029GP-TRT - Page 63

63
Chapter 4: Motherboard Connections
VGA Port Enable/Disable
Jumper JPG1 is used to enable or disable the VGA port on the I/O back panel. Close pin 1
and pin 2 for VGA support. The default setting is Enabled.
VGA Port Enable/Disable
Jumper Settings
Jumper
Setting
Denition
Pins 1-2 Enabled
Pins 2-3 Disabled
Manufacturing Mode Select



Manufacturing Mode Select
Jumper Settings
Jumper
Setting
Denition
Pins 1-2 Normal (Default)
Pins 2-3 Manufacturing Mode
Watch Dog
JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system
when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the
system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt
signal for the application that hangs. Watch Dog must also be enabled in BIOS. The default
setting is Reset.
Note: When Watch Dog is enabled, the user needs to write their own application software
to disable it.
Watch Dog
Jumper Settings
Jumper
Setting
Denition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled