Supermicro SuperServer 4029GP-TRT - Quick Reference Table

15
Chapter 1: Introduction
Note: Table is continued on the next page.
Quick Reference Table
Jumper Description Default Setting
JBT1 CMOS Clear Open (Normal) (See Chpt. 4)
JPG1 VGA Enable Pins 1-2 (Enable)
JPME1 Manufacturing Mode Select Pins 1-2 (Normal)
JVRM1 VRM SMBus Clock (to BMC or PCH) Pins 1-2 (BMC, Normal)
JVRM2 VRM SMBus Data (to BMC or PCH) Pins 1-2 (BMC, Normal)
JWD1 Watch Dog Timer Enable Pins 1-2 (Reset to System)
LED Description Status
LE1  
LE2 Power LED On: Onboard power on
LED 1 M.2 Power LED On: M.2 power on
LEDM1 BMC Heartbeat LED Blinking Green: BMC normal
Connector Description
BT1 Onboard CMOS battery
CN10/CN11 x4 Oculink Connectors connected to CPU2 for NVMe drive for HSSI add-on card use
COM1 COM port (COM1) for front access
FAN1-10
System cooling fan headers (Fan1-Fan 8) & active CPU heatsink fan headers (Fan9/
Fan10)
IPMI_LAN Dedicated IPMI LAN port
LAN1/LAN2 10GbE LAN Ethernet ports 1/2 on the I/O back panel
JF1 Front panel control header
JHFI1/JHFI2
Host Fabric Interface (HFI) sideband headers used for the HFI carrier cards (JHFI1
is used when an F model CPU is installed in CPU Socket 1; JHFI2 is used when an
F-model CPU is installed in CPU Socket 2.) (See Notes below.)
JHSSI1/2
Intel 81xx/61xx/51xx/41xx/31xx CPU-FPGA sideband headers (1/2) for CPU-FPGA
add-on cards
JIPMB1 4-pin System Management Bus (SMBus) I
2
C header (for an IPMI-supported card)
JL1 Chassis Intrusion header
JM2-1 PCI-E M.2 slot
JNCS1
Add-on card header used for the AOC that supports NCSI (Network Communication
Services Interface)
JNVI
2
C1/ JNVI
2
C2
NVMe SMBus (I
2
C) headers used for PCI-E hot-plug SMBus clock & data connections
(an SMCI-proprietary NVMe add-on card and cable are required for each NVMe
SMBus header. This feature is available for a Supermicro complete system only.)
JPW19/20, JPW 21/22 SMCI-proprietary power supply units 19/20, 21/22 for system use
JPWR1-8, JPWR9-16 8-pin GPU power supply connectors 1-8, 9-16
JRK1 Intel RAID Key header for NVMe SDD
JSDCARD1 BMC_SD card header
JTPM1 Trusted Platform Module/Port 80 connector
JUIDB1 