Supermicro SUPERSERVER 5018A-TN7B - Page 54

5-12
SUPERSERVER 5018A-TN7B User's Manual
Universal Serial Bus (USB)
Four Universal Serial Bus 2.0 ports
(USB2/3, 6/7) are located on the
I/O rear panel. One USB 2.0 header
(USB4/5) can provide front panel
access; USB1 is Type A connector.
Cables are not included. See the

USB4/5
Header Pin Denitions
 
1 +5V 2 +5V
3 USB_PN2 4 USB_PN3
5 USB_PP2 6 USB_PP3
7 Ground 8 Ground
9 Key 10 Ground
Ethernet Ports (LAN1/LAN2)
Seven Gigabit Ethernet ports (LAN1-7) are located on the I/O rear panel ports
accepting RJ45 type plugs. One of these is a shared LAN IPMI 2.0 port. They are:
• Quad GbE LAN with Intel C2000 SoC i354 - 2 pairs LAN bypass
• Single GbE LAN with Intel i210-AT
• Dual GbE LAN with Intel Ethernet controller i350-AM2 - 1 pair LAN bypass
Unit Identier Switch (UID)
The Unit ID switch is located on the I/O rear panel.
Serial Ports
COM1 port is located on I/O rear panel to provde a serial port connection. The
COM2 header is located next to the PCIe slot.
VGA
A VGA port is located next to the LAN6/LAN7 ports on the I/O rear panel.
Other Connectors