Supermicro SUPERSERVER 5018A-TN7B - Expansion Card Setup

SUPERSERVER 5018A-TN7B User's Manual
6-6
6-5 Expansion Card Setup

with one 3.5" drive or two 2.5" drives each with a single drive bracket, it accepts a

no room for an expansion card.
Figure 6-6. Install the Expansion Card and Riser Card
Riser Card
Expansion Card
Expansion Card Clip
Expansion Card Clip
Figure 6-5. Locate the Expansion Card Clip
1. Locate the expansion card clip on the back of the chassis
2. Remove the screws holding the expansion card clip and the dummy bracket
which covers the openings in the back of the chassis.
3. Remove the expansion card clip and the dummy plate from the chassis.