Supermicro SUPERSERVER 5018A-TN7B - Installing 2.5 Fixed Hard Drives

6-5
Chapter 6: Advanced Chassis Setup and Maintenance
Figure 6-4. Installing the 2.5" Hard Drives
Installing a Fixed 2.5" Hard Drive
The 2.5" hard drives must be installed in their brackets before they are screwed
into the chassis.
1. Power down the system and remove the power cord from the rear of the power
supply as described in Section 6-2. and remove the chassis cover
2. Insert 2.5" hard drives into the hard drive brackets.
3. Secure the 2.5" hard drives to the brackets with the screws provided.
4. Place the hard drive bracket in the chassis as illustrated above.
5. 
provided.
Installing 2.5" Fixed Hard Drives
Brackets