7-12
SUPERSERVER 5018A-TN7B User’s Manual
Pass Gate Minimum Repetition
Use this feature to specify the minimum number that the Pass Gate tests will be
repeated.
Fast Boot
Select Enabled to skip the routine memory procedure and attempt to boot the
are Disabled, and Enabled.
Smm Size (MB)
Use the keyboard to enter a value for the size of the SMM/TSEG region where 1
MB is aligned to.
Force Memory Map Ax
Select Enabled to force the BIOS setup utility to specify the total number of Kb (or
an error) of memory errors detected by the BIOS upon OS initialization. The options
are Enabled and Auto.
Memory Frequency
This feature sets the memory frequency limits for the DIMM modules installed on the
the motherboard. The options are Auto, DDR3-1333 (MHz), and DDR3-1600 (MHz).
Memory Channels
Auto and Single Channel.
MRC (Maximal Ratio Combining) Debug Messages
Use this feature to set the debug output display in MRC. The options are Disabled,
Minimum, Medium, and Maximum.
DDR Voltage
Use this feature to set the DDR3 voltage setting. The default option is 100.
Fine DDR Voltage
Auto, 1.25V,
1.35V, and 1.50V.
CKE Power Down
Select Enabled to enable CKE Power Down support which controls the low power
mode for RAM in the active power standby mode. The options are Enabled, and
Disabled.
To Next Page
Loading...
