19
Chapter 2: Maintenance and Component Installation
Chapter 2
Maintenance and Component Installation
This chapter provides instructions on installing and replacing main system components. To
numbers given.
system. Please follow the procedures given in each section.
2.1 Removing Power
Use the following procedure to ensure that power has been removed from the system. This
step is necessary when removing or installing non-hot-swap components or when replacing
a non-redundant power supply.
1. Use the operating system to power down the system.
2. After the system has completely shut down, disconnect the AC adapter power cord from
the power source.
3. Disconnect the power cord from the chassis.
To Next Page
Loading...
