61
Chapter 5: BIOS
Port 0 - Port 5 SATA Device Type (Available when a SATA port is detected)
Use this item to specify if the connected SATA device is a Solid State drive or a Hard Disk
Drive. The options are Hard Disk Drive and Solid State Drive.
Server ME (Management Engine) Conguration
•
• Operational Firmware Version
• ME Firmware Type
• Recovery Firmware Version
• ME Firmware Features
• ME Firmware Status #1
• ME Firmware Status #2
• Current State
• Error Code
PCIe/PCI/PnP Conguration
The following information will display:
• PCI Bus Driver Version
• PCI Devices Common Settings:
PCI PERR/SERR Support
Select Enabled to allow a PCI device to generate a PERR/SERR number for a PCI Bus Signal
Error Event. The options are Enabled and Disabled.
Above 4 G Decoding (Available if the system supports 64-bit PCI decoding)
Select Enabled to decode a PCI device that supports 64-bit in the space above 4 G Address.
The options are Enabled and Disabled.
SR-IOV (Available if the system supports Single-Root Virtualization)
Select Enabled for Single-Root IO Virtualization support. The options are Enabled and
Disabled.
*Onboard 10GbE LAN SR-IOV not supported on D-1540/D-1520.
To Next Page