12
SuperServer E200-9AP User's Manual
Jumper Description Default Setting
JBT1 CMOS Clear Open (Normal); Short: Clear CMOS
JI
2
C1/JI
2
C2 SMB to PCI-E Slots Enable/Disable Pins 1-2 (Enabled)
JPAC1 Audio Enable Pins 1-2 (Enabled)
JPL1 LAN1 Enable/Disable Pins 1-2 (Enabled)
JPL2 LAN2 Enable/Disable Pins 1-2 (Enabled)
JPME2
Maufacturing Mode
Pins 1-2 (Normal)
JWD1 Watch Dog Timer Pins 1-2 (Reset)
Connector Description
BT1 Onboard Battery
COM1-COM3
COM Ports supported by Novuton 5523D (COM1 in RJ45, COM1/2 support RS-232,
COM3 supports RS-485)
EDP1 Embedded DisplayPort (switch with VGA)
FAN1, FAN2 System/CPU Fan Headers (FAN1: CPU Fan)
HDMI, DP High Denition Multimedia Interface/DisplayPort
I-SATA0, I-SATA1 Intel SATA 3.0 Ports
JD1 Speaker Header
JF1 Front Panel Control Header
JGP1 General Purpose I/O Header
JL1 Chassis Intrusion Header
JMD1
M.2 PCI-E 2.0 x2 Slot / I-SATA Slot
JPH1
4-pin Power Connector for HDD devices (provides power from the motherboard to
system HDD devices.)
JPW1 24-pin ATX Power Connector
JPV1 12V 4-pin Power Connector
JSD1 SATA DOM Power Connector
JSTBY1 Standby Power Header
JTPM1 Trusted Platform Module/Port 80 Connector
LAN1/LAN2 LAN (RJ45) Ports
M2_SRW1, M2_SRW3 M.2 Mounting Screws
SLOT1 CPU PCI-E 2.0 X2 (IN X8) Slot
USB0/1 Back panel USB 2.0 Port
USB2/3 Back panel USB 3.0 Port
USB4 USB 2.0 Type A Header
USB8/9 Front Accessible USB 2.0 Headers
VGA VGA Port (switch with EDP1)
LED Description Status
LED1 Power LED S3 Blink Function Blinking Green: S3 function
LED2 System Power LED Solid Blue: Power On
LED3 P5V_STBY Power LED 5V Standby Power Ready
To Next Page
Loading...
