Supermicro SuperServer series - Page 54

SuperServer E200-9AP User's Manual
54
PCIe/PCI/PnP Conguration
PCI Bus Driver Version A5.01.08
PCI Devices Common Settings:
Above 4G Decoding
Select Enabled for 64-bit devices to be decoded above the 4GB address space If 64bit PCI
decoding is supported by the system. The options are Disabled and Enabled.
CPU SLOT1 PCI-E 2.0 X2 (INX8) OPROM
Use this feature to select the type of rmware to be loaded for the device installed on this
slot. The options are Disabled and EFI.
Onboard SAS Option ROM Type
Use this feature to select the type of rmware to be loaded for the onboard SAS. The options
are Disabled and EFI.
Onboard LAN Option ROM Type
Select Enabled to enable Option ROM support to boot the computer using a network device
specied by the user. The options are Disabled and EFI.
Onboard Video Option ROM
Use this item to select the Onboard Video Option ROM type. The options are Disabled and
EFI.
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI (Unied Extensible
Firmware Interface) for network stack support. The options are Disabled and Enabled.
Ipv4 PXE Support (Available when Network Stack is set to Enabled)
Select Enabled to enable Ipv4 PXE (Preboot Execution Environment) for boot support. If
this feature is set to Disabled, Ipv4 PXE boot option will not be supported. The options are
Disabled and Enabled.
Ipv6 PXE Support (Available when Network Stack is set to Enabled)
Select Enabled to enable Ipv6 PXE (Preboot Execution Environment) for boot support. If
this feature is set to Disabled, Ipv6 PXE boot option will not be supported. The options are
Disabled and Enabled.
PXE boot wait time
Use this option to specify the wait time to press the ESC key to abort the PXE boot. Press
"+" or "-" on your keyboard to change the value. The default setting is 0.