Chapter 1: Overview
1-5
X10DRS-2U/3U/4U Jumpers
Jumper Description Default Setting
JBT1 Clear CMOS See Chapter 2
JPB1 BMC Enable/Disable Pins 1-2 (Enabled)
JPG1 VGA Enable/Disable Pins 1-2 (Enabled)
JPL1 10G(T)_LAN1/2 Enable/Disable Pins 1-2 (Enabled)
JPME2 Manufacture (ME) Mode Select Pins 1-2 (Normal)
JWD1 Watch Dog Timer Enable/Disable Open (Disabled)
JPX1 PCI-E Switch (PLX) Enable/Disable Pins 1-2 (Enabled)
X10DRS-2U/3U/4U Connectors
Connectors Description
Battery(JBAT1) Onboard CMOS battery (See Chpt. 3 for Used Battery Disposal)
External SAS SAS 3.0 port on the IO backplane supported by Supermicro AOM-
S3008-L8-SB add-on module (AOM-S3008-L8-SB is required for
SAS support. See Note 1 P. 1-6)
FAN1-8 System/CPU fan headers (Fan1-Fan8)
JIPMB1 4-pin External BMC I
2
C header (for an IPMI card)
JKVM1 VGA/COM1/USB 0/1 (2.0) connector on the IO backplane
(SMCI-proprietary cable: CBL-0218L required. See Note 2 P. 1-6)
JPWR1 4-pin power header
JSD1/JSD2 SATA DOM (Device on Module) power connectors 1/2
JSLOT1 Slot1 PCI-E CPI-E 3.0 x24 (x8 + x16) (CPU1 Port2 + CPU2 Port3)
JTPM1 TPM (Trusted Platform Module)/Port 80 header
LAN1/2 10G(T)_LAN Ethernet ports 1/2 (LAN1: also used as IPMI LAN)
(JLAN1/2)
PM1/PM2 System power connectors
S-SATA 0/1 SATA 3.0 connectors supported by Intel SCU (S-SATA 0/1)
SAS Mezza-
nine Header
SMC-proprietary PCI-E 3.0 x8 Mezzanine slot w/SAS support (See
Note 1 on Page 1-6.)
USB 2.0 1/2 USB (2.0) 1/2 (JKVM1) on the IO backplane (See Note 2 Pg. 1-6)
USB 3.0 3 USB (3.0) 3 header onboard
To Next Page
Loading...
