Supermicro X10SRM-F - Super Io Configuration

X10SRM-F/-TF User's Manual
94
Onboard LAN2 OPROM (X10SRM-F only)
Use this option to select the type of device installed in LAN Port2 used for system boot. The
default setting for LAN2 Option ROM is Disabled.
Onboard 10G LAN Option ROM Type (X10SRM-TF only)
Use this feature to select which rmware type to be loaded for the onboard 10G LAN OPROM
option. The options are Disabled, Legacy, and EFI.
Onboard Video Option ROM
Use this item to select the Onboard Video Option ROM type. The options are Disabled,
Legacy, and EFI.
VGA Priority
This feature allows the user to select the graphics adapter to be used as the primary boot
device. The options are Onboard and Offboard.
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI (Unied Extensible
Firmware Interface) for network stack support. The options are Enabled and Disabled.
IPv4 PXE Support
Select Enabled to enable IPv4 PXE boot support. The options are Enabled and Disabled.
IPv6 PXE Support
Select Enabled to enable IPv6 PXE boot support. The options are Enabled and Disabled.
Super IO Conguration
The following Super IO information will display:
• Super IO Chip 2400
Super IO Chip Logical Device(s) Conguration
Serial Port 1
Serial Port 1 Conguration
This submenu allows the user the congure settings of Serial Port 1.
Serial Port 1
Select Enabled to enable the selected onboard serial port. The options are Disabled and
Enabled.
Device Settings
This item displays the status of a serial part specied by the user.