Super X11SRA/-F/-RF User Manual
82
INT19 (Interrupt 19) Trap Response
Interrupt 19 is the software interrupt that handles the boot disk function. When this feature
is set to Immediate, the ROM BIOS of the host adaptors will "capture" Interrupt 19 at boot
up immediately and allow the drives that are attached to these host adaptors to function as
bootable disks. If this feature is set to Postponed, the ROM BIOS of the host adaptors will
not capture Interrupt 19 immediately and will allow the drives attached to these adaptors to
function as bootable devices at boot up. The options are Immediate and Postponed.
Port 61h Bit-4 Emulation
This feature enables port 61h bit-4 toggling in SMM. The options are Disabled and Enabled.
Wait for "F1" If Error
This feature forces the system to wait until the "F1" key is pressed if an error occurs. The
options are Disabled and Enabled.
Re-try Boot
When EFI Boot is selected, the system BIOS will automatically reboot the system from an
EFI boot device after its initial boot failure. If Legacy Boot is selected, this feature will allow
the BIOS to automatically reboot the system from a Legacy boot device after its initial boot
failure. The options are Disabled, Legacy Boot, and EFI Boot.
Watch Dog Function
If this feature is set to enabled, the Watch Dog timer will allow the system to reboot when it
is inactive for more than ve minutes. The options are Disabled and Enabled.
Power Button Function
This feature controls how the system shuts down when the power button is pressed. Select 4
Seconds Override for the user to power off the system after pressing and holding the power
button for four seconds or longer. Select Instant Off to instantly power off the system as soon
as the user presses the power button. The options are Instant Off and 4 Seconds Override.
AC Loss Policy Depend on
Use this feature to set the power state after a power outage. Select Power Off for the system
power to remain off after a power loss. Select Power On for the system power to be turned
on after a power loss. Select Last State to allow the system to resume its last power state
before a power loss. The options are Stay Off, Power On, and Last State.
EuP Support
EuP, or Energy Using Product, is a European energy-saving specication that sets a standard
on the maximum total power consumption on electrical products. The options are Unchecked
and Checked.
To Next Page
Loading...
