Supermicro X11SRA - Bmc Network Configuration

Chapter 4: BIOS
91
Custom EFI Logging Options
Log EFI Status Codes
This feature allows the user to disable the logging of EFI Status Codes, enable Error code,
enable Progress code, and enable both codes. The options are Disabled, Both, Error code,
and Progress Code.
Note: All values changed here do not take effect until the computer is restarted.
BMC Network Conguration
BMC Network Conguration
Congure IPV4 support
The following features will be displayed:
• IPMI LAN Selection
• IPMI Network Link Status
Update IPMI LAN Conguration
Select Yes for the BIOS to implement all IP/MAC address changes at the next system boot.
The options are No and Yes.
*If Update IPMI LAN Conguration is set to Yes, the following features will become
available for user's conguration:
Conguration Address Source
This feature allows the user to select the source of the IP address for this computer. If Static
is selected, you will need to know the IP address of this computer and enter it to the system
manually in the eld. If DHCP is selected, the BIOS will search for a DHCP (Dynamic Host
Conguration Protocol) server in the network that is attached to and request the next available
IP address for this computer. The options are Static and DHCP.
Station IP Address
This feature displays the Station IP address for this computer. This should be in decimal and
in dotted quad form (i.e., 192.168.10.253).
Subnet Mask
This feature displays the sub-network that this computer belongs to. The value of each three-
digit number separated by dots should not exceed 255.
Station MAC Address
This feature displays the Station MAC address for this computer. Mac addresses are six
two-digit hexadecimal numbers.