Supermicro X8DTU - Page 30

Chapter 2: Installation
2-9
Note: Notch
should align
with the
receptive point
on the slot
Notch
Release
Tab
Release
Tab
DIMM DDR3
Notch
X8DTU/-F
To Install: Insert module vertically and press down until it
snaps into place. Pay attention to the alignment notch at
the bottom.
Installing and Removing DIMMs
To Remove:
Use your thumbs to
gently push the re-
lease tabs near both
ends of the module.
This should release it
from the slot.
3
Release Tab
Release Tab