4-22
X8DTH-6/X8DTH-6F/X8DTH-i/X8DTH-iF User's Manual
SET PEF Confi guration
PEF Support
Select Enabled to enable the function of Platform Event Filter (PEF) which will
interpret BMC events and perform actions based on pre-determined settings or
events and performs actions based on pre-determined settings or 'traps' under
IPMI 1.5 specifi cations. For example, powering the system down or sending an
alert when a triggering event is detected. The default is Disabled. If this item is
set to Enabled, the following items will display.
PEF Action Global Control (Available if PEF Support is enabled)
These are the different actions based on BMC events. The options are Alert,
Power Down, Reset System, Power Cycle, OEM Action, Diagnostic Interface.
Alert Startup Delay (Available if PEF Support is enabled)
This feature inserts a delay during startup for PEF alerts. The options are Enabled
and Disabled. If this item is enabled, the following item will display:
PEF Alert Startup Delay (Available if Alert Startup Delay is enabled)
This feature allows the user to select the delay time setting for PEF Alerts after
power-up from S4, S5 or Reset. The options are No Delay, 30 Sec., 60 Sec.,
1.5 Min., and 2.0 Min.
Startup Delay (Available if PEF Support is enabled)
Select Enable to enable startup delay support. The options are Enabled and
Disabled.
PEF Startup Delay (Available if Startup Delay is enabled)
This feature allows the user to select the delay time setting after PEF startup.
The options are No Delay, 30 Sec., 60 Sec., 1.5 Min., and 2.0 Min.
Event Message for PEF Action (Available if PEF Support is enabled)
Select Enable to enable Event Messages for PEF action. Refer to Table 24.6 of
the IPMI 1.5 Specifi cation for more information at www.intel.com. The options
are Disabled and Enabled.
BMC Watch Dog Timer Action
This feature Allows the BMC to reset or power down the system if the OS hangs or
crashes. The options are Disabled, Reset System, Power Down, Power Cycle.
BMC Watch Dog TimeOut [Min:Sec]
This is a timed delay in minutes or seconds before a power down or system reset
due to an OS failure. The options are [5 Min], [1 Min], [30 Sec], and [10 Sec].
To Next Page
Loading...
Need help?
General
