●If the blades stopped rotating. As lawn slope is greater than 20 degrees, or the front
wheels of the Intelligent Mower rushed to obstacles, automatic security system will
be activated to stop the blade. Remove the obstacles or slope and reboot.
5.4 Intelligent Mower exceed the fence in the process of running
The possible causes and simple resolving methods:
●The fence line is out of power. Check whether the red light of Intelligent
navigation workstation is on, if it is on, it is out of power and cannot send signal.
Pull out the plugs to find the causes, check whether the rope was drop off and the
plug was skidded off, and then re-insert it.
● the corner angle of the fence line is installed too small, so that the Intelligent
Mower crossed the line. Re-adjust the angle of fence line. It is required to be no less
than 90 degrees.
●The surrounding of lawn is the steep slope, for the installation of the fence line is
close to the edge, Intelligent Mower run out of line because of inertia. You need to
re-adjust the location of fence line, move it to the flat place.
5.5 Charge failure
The possible causes and simple resolving methods:
●The charging plug was not fully inserted into the socket of the smart mower.
Disconnect the charging plug on the mower, and re-connect it to continue charging.
●Power-cut in charging process. Pull out the charging plug, and re-plug to recharge
till the power-supply restores.
●The charging bars of the Intelligent Mower didn't contact the charging electrodes
of the Intelligent navigation workstations. When you find out the cause, push
forward the Intelligent Mower by manual way to make them fully contacted, or
filling the region below the wheels with soil to ensure that the Intelligent mower's
driving wheel and the plinth of the navigation workstations are at the same surface
level, to improve contacting conditions.
●The charging bars of the Intelligent Mower or the charging electrodes of the
Intelligent navigation workstations were dirty, so the electricity effect was affected.
Use brush or cloth to clean them up.
5.6 Unable to automatically return to charge
The possible causes and simple resolving methods:
●The area of lawn is too large, the path of fence line is too long, in the process of
searching the route back to the Intelligent navigation workstation, the power
consumption is too much so that the voltage is too low; make it unable to continue to
search. Take the intelligent mower back to the station for recharging.
●The power of the fence line is cut and no signals can be sent out, the Intelligent
Mower can not find the Intelligent navigation workstations for charging. Restore
electricity of the fence line or manually take the Intelligent Mower back to the
station to recharge.
25
5.4 Intelligent Mower exceed the fence in the process of running
5.5 Charge failure
5.6 Unable to automatically return to charge
To Next Page
Loading...
Need help?
General