6.1 The panel of the mower
The mower's ground board needs to be checked, and if necessary in the operation, it
needs to be cleaned. Sometime, if there is coverage on the surface of the mower or
the grass pieces gathered in the machine's ground board, especially damp ground
and wet grass.
You can use small branches or other tools to remove the gathered grass, carefully
scrape the grass pieces below the machine. If necessary, it needs to be leaned on
other surfaces to better contact with the bottom areas. Take the blade off to make it
easier to clean the grass pieces.
Warning! Serious accidents may occur, before lifting the machine, DO
remove the key to the power and pull out the fuse, sharp blades may cut your hand,
remember to wear thick gloves when you touch the edge of the blade.
6.2 blades
Before the operation of machine, check whether the blades were damaged and if
they are damaged, replace the blades in time. Do not use damaged blades, Only use
good blades. It is undesirable to sharpen the blades with mechanical device,
because sharpening it in this way frequently will make the body blade lost balance.
if necessary ,contact with local dealer to obtain blades supplied by manufacturer.
6.3 Exterior Shell
Use wet cloth and dry brush to clean the surface of the machines; detergent can be
used, soak and pinch the cloth to wipe the surface, do not use sandblasting cleaning
method and do not use the garden hose or other hoses to wash it.
26
6.1 The panel of the mower
6.2 blades
6.3 Exterior Shell
Chapter Six Attentions and Maintenance
!
To Previous Page
Loading...
Need help?
General