Need help?Do you have a question about the Sure Electronics JAB4 and is the answer not in the manual?
Connects to DC10V-26V power supply via Molex MicroFit connector.
Supports battery power via WONDOM BCPB series using PH-4Pos connector.
Supports Bluetooth 5.0 with aptX, aptX HD, aptX LL, SBC, AAC codecs.
Features both built-in and external antenna ports for connectivity.
Accepts 3.5mm AUX IN via PH-6pos-2mm terminal block.
Indicates Bluetooth status: ON when paired, BLINKING when searching.
Indicates signal presence: ON when detected, OFF when no signal.
Connect JAB4 with ICP5 for SigmaStudio or PC UI control.
J10 port controls standby mode; short circuit activates standby.
Four ports for hardware control of gain, filters, etc. via potentiometers.
Customizes frequency range (HPF, BPF) via software interfaces.
Short circuit J2 or use button to cancel Bluetooth pairing.
Supports 4x30W, 2.0/0.2 mode (2x60W), 2.1 mode (2x30W+1x60W).
Details speaker output configurations for different operational modes.
Provides I2S output for cascading with other I2S amplifier boards.
General| Brand | Sure Electronics |
|---|---|
| Model | JAB4 |
| Category | Amplifier |
| Language | English |
To Next Page
