SureCall Force-5 - Page 15

TROUBLESHOOTING
SureCall Force-5 Cellphone-Mate, Inc. Page 15
All rights reserved.
Problem
Resolution
Your booster restarted
and shut down for 15
minutes, and is now shut
down permanently.
Each SureCall booster is equipped with Auto Shutdown
to prevent cell tower interference. The outside antenna
may be close to a cell tower. Move the outside antenna to
a location that provides sufficient distance from the cell
tower to prevent the booster from automatically enabling
Auto Shutdown. Once away from the original location,
perform the procedure under
Step 4. Connect to AC
Power on page 9.
The red LED goes ON.
More antenna separation is needed. If you cannot
provide more antenna separation and the Alert LEDs
flash after the initial activation period, lower the switch
below the blinking LED by 5 dB (for example, from 50 to
45) and monitor the bars on your cell phone to see
whether reception improves.
The Power LED does not
turn ON.
Be sure the AC outlet is working and is not controlled by
a wall switch that can remove power from the outlet.
The Alert LEDs flash
after the initial activation
period.
Lower the switch below the blinking LED by 5 dB (for
example, from 60 to 55) and monitor the bars on your cell
phone to see whether reception has improved.
The Alert LEDs continue
to flash.
The booster shuts down automatically, and then restarts
after 60 seconds. Turn down the switch that is oscillating
(for example, Cellular-800 or PCS-1900) to prevent the
booster from shutting down automatically.