SP91 User Manual
one NV bit image n=1, the printer only processes the data group [xl xH yL yH dl...dK]
once. The printer uses ([data:(xL+xH × 256) × (yL+yH × 256) × 8]+[header:4]) bytes of
the NV memory.
· The definded area of this printer is 192K bytes (max). This command can define
several bit images, but can ’ t define the bit image which the total capacity [bit image
data+head] overs 192K bytes.
· Whatever how to set DIP switch 2-1, the printer enters “ busy ” before writing NV
memory.
· Even set ASB, the printer do not send the ASB status or execute status test during
process this command.
· When receive this command during macro definition, the printer stops macro
definition and executes this command.
· Once defines one NV bit image, it can ’ t be executed ESC @, and deleted when reset
and power off.
· This command only executes the definition of NV bit image, do not execute print. NV
bit image print executed by FS p.
[Notes] · Writes command frequently which could be broken the NV memory.
So, suggests that executes the written operation less than ten times.
After the process of putting one bit image into NV memory, the printer executes one
hardware reset operation. So, defines the user-defined character, download bit image
and macro after finishing this command. The printer clears receive and print buffer area,
and reset to the effective mode when turing the power on. At this moment, the switch
DIP set will be checked once again.
[Reference] FS p
[Examples] When xL = 64, xH = 0, yL = 96, yH = 0.
To Next Page
Loading...