SurePrint SP91 - DLE EOT N

SP91 User Manual
[Reference] ESC
ESC
ESC
ESC 2
2
2
2 ， ESC
ESC
ESC
ESC 3
3
3
3
CR
CR
CR
CR
[Name] Print and carriage return
[Format] ASCII CR
HEX 0D
Decimal 13
[Description] Allow feed paper automatically, the function of this command is the same as LF
command.
This command will be ignored when do not allow to feed paper automatically.
[Pa r ticularize] · For serial interface mode, the feed paper fu n ction of this command could be ignored.
·· This command set the print position to the starting of the line.
[Reference] LF
LF
LF
LF
DLE
DLE
DLE
DLE EOT
EOT
EOT
EOT n
n
n
n
[Name] Transmit real-time status
[Format] ASCII DLE EOT n
HEX 10 04 n
Decimal 16 4 n
[Range] 1 ≤ n ≤ 4
[Description] Transmit the real-time status. Parameter n used to be appointed the printer transmitting
status. The definition as follows:
n = 1: Transmit printer status.
n = 2: Transmit offline cause status.
n = 3: Transmit error cause status.
n = 4: Transmits roll paper sensor status.
[Particularize] • The printer transmits the current status, each status is one byte data.
• When transmitting the status, the printer can not confirm whether the host can
receive the data or not.
• Starts to execute when the printer received this command.
• In serial interface mode, even if the printer lacated on offline status, full receiving
buffer, or executed this command when error occurred.
• In parallel interface mode, can not execute this command when the printer is busy.
When the printer located in offline status, Memory Switch 1-3 lacated on ON, the
printer can not go to BUSY status.
• Reply (ASB) automatically through GS a command, need to make a distinction the
sending s t atus of DLE EOT command and ASB status. （ Refer to appendix C,
transmitting status identification ）
• If the printer don ’ t be selected peripheral device command ESC = , the selected
command remain in effect.
[Notes] · Whenever get <10>H<04>H<n>(1 £ n £ 4) data sequence, will transmit the
status.
For example in the following commands ：
ESC
ESC
ESC
ESC *
*
*
* m
m
m
m nL
nL
nL
nL nH
nH
nH
nH d1
d1
d1
d1 ...
...
...
... dk
dk
dk
dk , d1 =<10>H, d2 =<04>H, d3 =<01>H
· Can not use this command when there are 2 or more bytes in the command.
For example ：