7.0 REMOTE CONTROL
PLEASE NOTE: Your remote control is located in your MGI Pouch,
along with the remote holder clip.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
7.1 CHARGING YOUR REMOTE CONTROL
Before you start using your Ai Navigator GPS
+
you must fully charge
the remote control battery for approximately 6 hours using the USB
cord provided. The LED will flash while charging. When a full charge is
complete, the LED will stay on.
To charge the remote, plug the USB cord into the USB port at the
base of the remote. The cable can be plugged into the USB port
underneath the Ai Navigator GPS
+
handle, a PC or Laptop for
charging.
Alternatively, plug the cable into an AC adaptor [not provided].
To turn on your remote hold the button located on the top of the
remote until the blue light appears. If no light appears then it needs
to be charged.
To check the remote battery percentage, press the main battery
icon on the bottom right of your Ai GPS
+
screen.
We recommend recharging your remote battery when recharging
your main battery aer each use.
7.2 REMOTE LED COLOURS AND STATUS
• Solid Blue: Connected (Paired Mode) & Battery Above 25%
• Blinking Blue: Searching For Bluetooth Connection (Pairing Mode)
• Solid Red: Battery is below 25%
• Blinking Red (Plugged In): Device is Charging and below 75%
MGI Ai Navigator GPS
+
User Manual 1.0 17
MODEL: NAVIGATOR Ai Remote
FCC ID : 2BA2LG7GPS
IC : 30328-G7GPS
CAN ICES-3 (B)/NMB-3(B)
To Next Page
Loading...
Need help?
General
