3.2 ATTACHING THE FRONT WHEELS
The two front wheels need to be attached to your MGI Ai Navigator
GPS
+
. There is no dierence between each front wheel so either
can be placed on the le or right side. Lubricate the axles with the
Lubricant Cloth in the MGI Pouch. Simply line up the silver pin on
the front wheel with the Ai Navigator GPS
+
and push into the frame
until you hear a positive click. A black button on the side of the Ai
Navigator GPS
+
frame just above the wheel connection will pop out
to confirm the wheel is in the correct position. You can test the wheel
is in position by pulling firmly on the wheel. It should not move out of
position.
3.3 REAR WHEELS POSITIONS
The MGI Ai Navigator GPS
+
is designed to allow the rear wheels to
be in two positions. The position is determined by where the wheel is
locked on the axle in either of the two grooves [see picture].
The drive position is used during the normal operation of the Ai
Navigator GPS
+
. The free wheel position is used to freely push the Ai
Navigator GPS
+
should you choose not to use your battery, allowing
for a manual push instead of battery powered.
MGI Ai NAVIGATOR GPS
+
User Manual 1.0 7
To Next Page
Loading...
Need help?
General
