SUSS CIC1200 - Additional Functions; Switching Off the Lamp

OPERATING PROCEDURES
OP CIC1200 E Rev4.0 06-09 Chapter 4 27
4
4.10. Additional Functions
4.10.1. Full Reset
Meaning: Reset all calibration data.
Function:
The alphanumeric display shows:
STAND-BY
Press key CH2 for 3 sec. and max 1 sec later
START.
_ RES ET? _
Press START
_ RES ET _ _
STAN D-BY“
4.11. Switching Off the Lamp
To switch off the lamp press button OFF on left of the
CIC front panel. The lamp will be switched off imme
-
diately. The CIC itself will be still in „stand by“ mode
with an internal timer controlling the cool down time
of the lamp, to prevent re-ignition before the lamp is
ready again.
To de-energize the CIC completely it must be dis-
connected from the mains supply:
Technique for such disconnection and re-supply of
the unit may depend on the specific machine type in
which the CIC is used.