115
6
6-1. Phone operation (Hands-free system for cellular phones)
Phone
COROLLA_HV(TMUK)_OEM_MM_(EE)
Select to display the keypad to
send tones. (P. 11 5)
Select to send tones. This but-
ton only appears when a num-
ber that contains a (w) is dialed
in hands-free mode. (P.11 5)
Select to adjust your voice vol-
ume that the other party hears
from their speaker. (P. 11 6)
Select to mute your voice to the
other party.
Select to change handset
modes between hands-free and
cellular phone.
Select to put a call on hold. To
cancel this function, select “Acti-
vate”.
Select to hang up the phone.
●
When cellular phone call is changed
to hands-free call, the hands-free
screen will be displayed and its func-
tions can be operated on the screen.
●
Changing between cellular phone call
and hands-free call can be performed
by operating the cellular phone
directly.
●
Transferring methods and operations
will be different depending on the type
of Bluetooth
®
phone you have.
●
For the operation of the cellular
phone, see the manual that comes
with it.
■
By keypad
1 Select “0-9”.
2 Enter the desired number.
■
By selecting “Release tones”
“Release tones” appear when a
continuous tone signal(s) contain-
ing a (w) is registered in the contact
list.
1 Select “Release tones”.
●
A continuous tone signal is a charac-
ter string that consists of numbers and
the characters “p” or “w”. (e.g.
056133w0123p#1)
●
When the “p” pause tone is used, the
tone data up until the next pause tone
will be automatically sent after 2 sec-
onds have elapsed. When the “w”
pause tone is used, the tone data up
until the next pause tone will be auto-
matically sent after a user operation is
performed.
●
Release tones can be used when
automated operation of a phone
based service such as an answering
Talking on the
Bluetooth
®
hands-free
system
While talking on the phone, the
following screen is displayed.
The operations outlined below
can be performed on this
screen.
Call screen operation
A
B
C
E
F
Sending tones
To Next Page