Suzuki VL1500K5 - To Sensor Inspection

120 VL1500K5 (’05-MODEL)
TO SENSOR INSPECTION
The tip-over sensor is located under the front seat.
(!Page 70)
TO SENSOR REMOVAL/INSTALLATION
• Remove the seats. (!Page 121)
• Disconnect the coupler

1 and remove the TO sensor.
• Installation is in the reverse order of removal.
NOTE:
When installing the TO sensor, bring the “UPPER” letter

A on it
to the top.
HO2 SENSOR INSPECTION
(FOR E-02, 19, 24)
The heated oxygen sensor is installed on the pre-muffler.
(!Page 87)
HO2 SENSOR REMOVAL/INSTALLATION
• Remove the seats. (!Page 121)
• Disconnect the coupler

1 and remove the HO2 sensor unit.
$
'
• Installation is in the reverse order of removal.
'
• Tighten the sensor unit to the specified torque.
& HO2 SENSOR: 25 N·m (2.5 kgf-m, 18.0 lb-ft)
• Route the HO2 sensor lead wire properly.
(!Page 145 and 146)
Do not remove the HO2 sensor while it is hot.
Be careful not to expose it to excessive shock.
Do not use an impact wrench while removing or
installing the HO2 sensor unit.
Be careful not to twist or damage the sensor lead wire.
Do not apply oil or other materials to the sensor air
hole.
SAMPLE